Anker SOLIX S5000 + Renogy 400W Solar Suitcase + Free 50-Ft Cables

Set up daylight charging for the Anker SOLIX S5000 without committing to a roof-mounted array. This AllProGenerators kit pairs the 5,024Wh, 120/240V power station with one Renogy 400W Lightweight Portable Solar Suitcase and a free pair of 50-foot solar extension cables. The cable pair lets you find a sunny spot for the panel while keeping the station in a protected, ventilated location.

What comes with this S5000 solar kit

• One Anker SOLIX S5000 power station and its standard factory accessories.
• One Renogy 400W folding solar suitcase with kickstands and a carry case.
• One red and one black Rich Solar 50-ft 10 AWG solar extension cable, included free.
• One MC4-to-XT60i solar charging lead for the S5000 low-PV input.

Best use cases

• Selected 120V and 240V backup loads. Power a refrigerator, lights and communications equipment, or plan for a compatible 240V load such as a well pump. Check its starting current, continuous draw and outlet limits before counting on it in an outage. Hardwired circuits require compatible transfer equipment installed by a qualified electrician.
• Remote workshops and cabins. Roll the S5000 into a protected workspace and deploy the suitcase outside. Run task lighting and compatible tools while the array contributes daytime energy. Scheduling higher-draw tasks separately leaves more room for startup surges.
• 30-amp RV staging or extended stays. The S5000 has a 120V TT-30R outlet. Budget for the actual draw of your RV loads and keep the station protected while the panel sits in open sun. This is most useful when lighting, refrigeration and device charging matter more than running air conditioning for hours.
• A backup system you can build out. Start with one portable panel and add compatible BP5000 batteries later if you need more stored energy. Plan additional solar separately around the S5000’s input limits and the energy you use per day.

How the 400W suitcase connects

Unfold the Renogy suitcase and position it in clear sun. Run the red and black extensions between the panel and the included MC4-to-XT60i lead, then connect the lead to the station’s low-PV input, following the manufacturer instructions. One panel’s 40V operating voltage and 10A operating current fit that input’s 11–60V and 17A limits. Keep polarity correct and verify that the panel’s cold-weather open-circuit voltage remains under the input limit.

The 400W rating is for standard test conditions. If the panel averages 300W for four hours, it supplies about 1.2kWh before cable and conversion losses. That is a useful top-up for a 5kWh battery. Plan another charging source or a compatible larger array if you regularly use most of the battery.

Full specifications

Frequently asked questions

Do I need two Renogy 400W panels for the S5000?

One panel is enough for the supplied low-PV setup. The kit includes one 400W suitcase and the correct lead. A second matching suitcase wired in series would exceed the low-PV voltage limit. Use Anker’s input limits and wiring guidance when designing a larger array.

Can this run a 240V well pump?

The S5000 has 120/240V split-phase output. Whether it can start a particular pump depends on the pump’s starting demand, its running draw and the connection method. The 8,000W peak is brief. Have an electrician verify compatibility and install any needed transfer equipment.

Will the solar suitcase fully recharge the S5000 in one day?

A full recharge from empty requires more than 5kWh of input after losses. The included 400W panel is best suited to extending runtime and replacing part of a day’s energy use. Output changes with sun, orientation, shade and temperature.

Can I connect the S5000 to the Anker SOLIX Home Power Panel?

Anker specifies that the S5000 is incompatible with its Home Power Panel. For selected home circuits, have an electrician specify compatible transfer equipment for the S5000.

Can I add batteries later?

Yes. The S5000 supports up to five compatible Anker SOLIX BP5000 expansion batteries. Expansion batteries and transfer hardware are available separately.

What do the 50-foot cables add?

The kit includes two 50-foot leads, one per polarity, for an extension of about 50 feet between panel and station. Use them when the sunniest spot is away from your garage, RV or covered station location.

Manufacturer photos may show separately sold equipment. For other configurations, see the Anker SOLIX S5000 collection or the standalone S5000 and factory kit options.